UNRESERVED - 1996 Radford R400 Cutter Sloop
Located: Tin Can Bay, Queensland
Inspection Highly Recommended
Online Auction: bidding to commence on Tuesday, 25 August 2026 and will end on Monday, 31st August 2026 at 2pm AEST
- Bottom hull plate 4mm, Topside 3mm, Frames and Backbone 8mm, Floors, Skeg and Keel plate 4mm.
- LOA 12.2m LWL 11.56m Draft 1.6m Beam 3.6m
- Weight 11 Tonne
- Engine – Nissan SD23 Diecon 60HP approx. 1500 Hrs, 440mm 3 blade Bronze prop on 35mm shaft.
- Sails : main sail full battened, Reefurl headsail, Staysail/Storm Jib
- Mast : Deck stepped twin swept back. Barlow winches. Steering – Wheel with chain and wire to quadrant
- Instruments: Raymarine. Engel Fridge Freezer, 12/240V. Domestic Hold and Cold Pressure System.
- Water : 550L in 3 stainless tanks and 1 plu tank.
- Fuel 350L
- Anchor : 50lb and 30lb. chain : 70 m Anchor winch : Maxwell VW1200
- TMC Toilet, Wind Generator, 3 Burner Gas Stove & Oven. BBQ, Bose Entertainment system.
- Coursemaster CM85i , Dometic Air Conditioning System
- Batteries: Start Battery Blue Top Optima D31M. 3 x House Batteries Ultimate Extreme
- There is some rust inthe boat requiring repair.
For a full list of specifications, photos and an inspection contact:
Todd Anderson - 0409 630 733
Email: todd@marineauctions.com.au
or
Adrian Seiffert - 0418 783 358
Email: adrian@marineauctions.com.au
To Register visit - www.marineauctions.com.au
Online Auction Terms, Buyers Premium 7.5% excluding GST applies. 10% Deposit at the close of the Online Auction and balance of the purchase
price to be paid in full at settlement on or before Monda, 7 September 2026 sold in AUD DOLLARS.
DISCLAIMER:
Marine Auctions offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor
warrant the condition of the vessel. As the vessel is sold” As Is Where Is” Marine Auctions highly recommends that every potential
purchaser inspect or arrange a surveyor or representative on their behalf to inspect the vessel prior to bidding
